How To Inject Water For Common Two-wheeled Fire Fighting Motorcycles?
Due to the advantages of small size and strong power, two-wheeled Fire Fighting Motorcycles are widely used in narrow areas and traffic dredging. Recently, I have seen many small partners searching for the question of how to inject water into two-wheeled Fire Fighting Motorcycles.The Rescue Equipment of the Fire Fighting Motorcycle is arranged at the rear of the motorcycle and on the left and right sides of the rear. Yellow gas cylinders, coiled tubes and warning lights are placed at the rear. There are water tanks on the left and right sides, which are foam liquid and water respectively. When encountering a fire, use the gas cylinder to provide pressure, spray the liquid in the water bottle, and pull out the coiled pipe to extinguish the fire. The spray gun can choose two
kinds of water mist and foam liquid.
How to fill the two-wheeled Fire Fighting Motorcycle with water? In fact, there will be a special water injection port on the water tank. Before use, pour water into the water tank or inject foam liquid through the water injection port. However, we still recommend that the water tank should be kept full at ordinary times to avoid the problem of no water in the water tank in case of emergency. As for the four-wheeled Fire Fighting Motorcycle, its water injection method is actually the same as that of the two-wheeled fire-fighting motorcycle. The difference is that it is larger than the two-wheeled motorcycle and carries more fire-fighting equipment.Note that if there is no water in the water tank during use, you need to add clean water when adding water, because if you add water with impurities, it is likely to cause problems such as hose blockage and no water outlet during use.
